• Got the Contributing Memberships stuff finally worked out and made up a thread as a sort of "How-To" to help people figure out how to participate. So if you need help figuring it out, here's the thread you need to take a look at -> http://www.corvetteflorida.com/forums/showthread.php?t=3581 Thank you, everyone! Rich Z.

Anyone ever replace a FWD clutch?

raidmagic

raidmagic

New member
My brother-in-law burned up the clutch in his 92 Saturn. I've never done a fwd clutch before. Anyone do one? Any special tools needed?
 
I did mine in my GSX. . . kind of a pain but because of the transfer case and such, but there arent any "special" tools other that the correct centering tool
 
Cool, thanks. The car should be here tomorrow so I'll check it out and see what's involved. I've done tons of simular repairs but always on rear wheel drive cars. I think I'll run out and buy a manual for it too just to referece if needed.
 
Well we decided that the car isn't worth fixing so he is going to just buy a motorcycle and forget the car. Thanks for the input though.
 
Pulled the engine and tranny out of a 98 V6 Accord. That was a tight fit right there... I doubt that there would be enough room to drop the tranny independant of the engine.

For future reference: When pulling an engine or tranny out of a FWD car, it is sometimes better to leave the engine/tranny on the suspension, unbolt the engine/tranny/suspension, and lift the car off of the engine.
 
You must log in or register to reply here.
Back
Top