• Got the Contributing Memberships stuff finally worked out and made up a thread as a sort of "How-To" to help people figure out how to participate. So if you need help figuring it out, here's the thread you need to take a look at -> http://www.corvetteflorida.com/forums/showthread.php?t=3581 Thank you, everyone! Rich Z.

C3 F/S 1975 Stingray

RSS Feed

RSS Feed Robot
1975 Stingray in serious need of new paint.

L48 350 cubic inch engine.
Edelbrock carb and intake.
K&N filter and filter top.
Rebuilt distributor set to performance advance via the "Corvette Papers" with all new ign parts including plugs, wires, etc.
4 into 1 headers, high flow Magnaflow cats and true dual exhaust.
Dynoed at 185hp at the wheels/249 lb-ft torque (Quintin Brothers)

TH400 trans.

EBC green stuff pads and front rotors. Poly bushed front upper and lower A-arms. Poly bushed trailing arms with stainless adjustment shims and VBP radius rods.

On car now is 15x8 turbines and Cooper Cobra GTH new last year.
Comes with 93 Vette sawblades 17x8.5 front and 17x9.5 rear with 3 inch spacers and all hardware. Hoosier r6 rubber.

Recaro cloth seats.

Comes with or will sell separately 96 LT1 police interceptor engine--disassembled, cleaned and painted with some new gaskets for rebuild. 4L60e Trans. No engine harness as I was going to use a Painless Wiring set-up.

2 inch hitch and trailer wiring.

$5000 or best offer.

Thanks for looking,

George


Source...
 
Back
Top